Sniper 150 General Thread

[JapSpeed]

Anyone think t150 footrest is quite low...myb need to change into racing footrest..View attachment 33336 View attachment 33337 View attachment 33336 View attachment 33336 View attachment 33337

if you're not comfortable with the original footrest, yes you can upgrade it to aftermarket rear set.. for me original foot rest is okay..

 

[jangbest]

Anyone think t150 footrest is quite low...myb need to change into racing footrest..View attachment 33336 View attachment 33337 View attachment 33336 View attachment 33336 View attachment 33337

bro it was normal on stock foot rest ...
and I think your were right you must upgrade to racing foot rest for more banking hehehe ....

 

[Pseudocify]

Haha..i alrdy thought bout dat..but racing footrest jz make passenger feel unconfortable..

 

[turborotot]

I've posted this on Facebook, might as well post it here

Noob question po mga sir. Musta na po yung mga may issue na mausok na Sniper? Ano po ginawa sa casa para mawala ung usok, ano po ginawa/pinalitan? valve seal? piston ring? piston sleeve? valve timing? Cost?

Meron na usok sakin, hindi siya moisture or condensation pagumaga ha. Mausok lalo na pag wide open throttle, grey at blueish at times

Break in: HARD!
Odo: 9671km
Oil: 10w50 Putoline
Gas: Premium 95 octane

 

[K3rn]

I've posted this on Facebook, might as well post it here

Noob question po mga sir. Musta na po yung mga may issue na mausok na Sniper? Ano po ginawa sa casa para mawala ung usok, ano po ginawa/pinalitan? valve seal? piston ring? piston sleeve? valve timing? Cost?

Meron na usok sakin, hindi siya moisture or condensation pagumaga ha. Mausok lalo na pag wide open throttle, grey at blueish at times

Break in: HARD!
Odo: 9671km
Oil: 10w50 Putoline
Gas: Premium 95 octane

As per sa kilala kong mekaniko ng motor... Sir try niyo muna palitan yung fuel ng "unleaded" which is recommended by the manufacturer since hindi kaya iburn ng ng makina ng motor na tin and also according to him it might cause blockage of the FI system in the long run (will need frequent cleaning)...unless other wise kasing laki ng makina ng kotse natin yan na upgraded na rin at power hunger talaga... just my 2 cents.. =)

 

[turborotot]

As per sa kilala kong mekaniko ng motor... Sir try niyo muna palitan yung fuel ng "unleaded" which is recommended by the manufacturer since hindi kaya iburn ng ng makina ng motor na tin and also according to him it might cause blockage of the FI system in the long run (will need frequent cleaning)...unless other wise kasing laki ng makina ng kotse natin yan na upgraded na rin at power hunger talaga... just my 2 cents.. =)

Thanks K3rn

 

[JapSpeed]

I've posted this on Facebook, might as well post it here

Noob question po mga sir. Musta na po yung mga may issue na mausok na Sniper? Ano po ginawa sa casa para mawala ung usok, ano po ginawa/pinalitan? valve seal? piston ring? piston sleeve? valve timing? Cost?

Meron na usok sakin, hindi siya moisture or condensation pagumaga ha. Mausok lalo na pag wide open throttle, grey at blueish at times

Break in: HARD!
Odo: 9671km
Oil: 10w50 Putoline
Gas: Premium 95 octane

check piston ring or valve seal...

 

[king_f_i]

check piston ring or valve seal...

Sir japs... did you try pitsbike block 62mm in ur king? Longlasting for daily use or a month only

 

[JapSpeed]

yes bro.. i tried pitsbike block 62mm. tested..

 

[snipermxmalayaklan]

Sir's, Reminder: YOU ARE ON INTERNATIONAL SECTION, Please post in ENGLISH. Peace. happy newyear.

 

[Carlomx150i]

Good day forumers,, can you teach me about racing cams, and how they work like power band, lift, is it plug and play, like cms 5.8, or any other racing camshafts,, im planning to upgrade the cams of my snipermxking.

Thank you guys for your answers and knowlegde,

 

[ike]

As per sa kilala kong mekaniko ng motor... Sir try niyo muna palitan yung fuel ng "unleaded" which is recommended by the manufacturer since hindi kaya iburn ng ng makina ng motor na tin and also according to him it might cause blockage of the FIsel system in the long run (will need frequent cleaning)...unless other wise kasing laki ng makina ng kotse natin yan na upgraded na rin at power hunger talaga... just my 2 cents.. =)

puede rin sir ng nitro racing for me it helps

 

[king_f_i]

any one use uma 62mm for thier king? issue in stock tensioner someone tell not fit... ned replace tensioner cost of 450php idk wat brand.. ? sir @JapSpeed

 

[JapSpeed]

any one use uma 62mm for thier king? issue in stock tensioner someone tell not fit... ned replace tensioner cost of 450php idk wat brand.. ? sir @JapSpeed

you can't use your stock tensioner to uma 62 block... try stock mx 135 or mio tensioner, better try manual tensioner..

 

[JapSpeed]

 

[boldstardex]

heads up everyone just reminding that you are on an english speaking thread.

 

[gdeezzyy]

hello guys, if i change my rear sprocket from 42t to 45t? will it affect the accuracy display in my speedo? thanks