hows the performance of faito turbo cams and faito bore kit?

update mo ko sir ah. pang every day use lang kc gsto ko eh.

naka rcdi na pala ko ngaun s4 mtrtvspring
d ko alam kng ano pa dapat blhin pRa maaus na takbo ko

sir txt mo n lng ako sir 09268479466 sir ung cam yan kelangan mglng tlg mechanic at may gmit sa cam timing for advance settings sir pareho tayo ng problema sa faito cams sir nd p nmn nagrereply anf faito website kung maiaayos lng sna faito cam tiyak tlg na mblis po iyan

cge sir salamAt.

MGA MASTERS ANO-ANO PA PO BA MGA KINAKAILANGAN GAWIN KUNG GAGAMIT NG FAITO BORE KIT AT TURBO CAMSHAFT?

par

pareho tayo ng mods bro, ang 60mm faito i use it almost a week palang kaso 7km palang tinatakbo naka on na ang fan. sayo nong bago ganito rin ba?

kamu

boss kamusta pagpalit ng vspring mo

un hirap n hirap po maglgy mechanic ko ng valve spring he.he ung cms n bgo...tpos nagcms cam po ako kso ung isang pin nito eh baon kya un 2ng mechanic ko nmn sbi ok lng daw kht baon un nd n andar motor ko

up

just installed 60mm faito block, snam cams, mtrt vsprings, port and polish, keihin 28mm. so far so good. what we did is we run the engine on idle for half day like initial break in. Also we made the radiator fan to constantly run once we switch the ignition to on. This purpose is just to provide excellent cooling for the bike. On initial obsevation we dont think that it will overheat even on long rides, of course this is with fine condition coolant and radiator.

up

up for turbo cams

Same tau pafs palagay ko di nman mg ooverheat using faito 60mm..btw i used motul inugel coolant...i think it performs better nman..break in pa ako di ko pa ma hataw.

paps planning to install cms cam and cms valve spring sa vixion ko.....ano malamang na maencounter na problema ng mekeniko dyan? umandar na ba motor mo ngayon using both cms item? feedback naman dyan ano performance....tanx

there is really no problem installing the cam and spring and its up to the mechanic on how to install it and if he would to some valve pocket and adjusting the valve clearance so that the valve and piston wouldnt kiss and buy new valve seal...